Vragen werden met namen in het eerste gesprek gebaseerd op de uitkomsten van de LTP test en dus hoe jij zou reageren/werken binnen een team. Ze willen echt weten hoe je reageert op bepaalde situaties ipv de kennis die je mee neemt naar binnen.
Rf Engineer Interview Questions
1,141 rf engineer interview questions shared by candidates
lnas, filter, Pa, ip3, noise figure, smith chart, test setups etc
If I remember correctly, it was something to do with single/double balanced topologies. I am not quite sure if this was the question, the interview was several months ago.
tell about your current role/position
3. what is the modulation used in GSM voice? difference between GMSK and QPSK? which PA will you use for GMSK (linear or non-linear)
about Wifi standards, rf test equipment
Give the below circuit how much power will be transfered, how to find the total noise power at the output. Why is IQ conversion is done in transceiver
Asked me about QAM, OFDM, BER
How does noise floor change before and after the LNA stage?
Difference between LNA and PA? Can they be interchangeably used? Why or why not?
Viewing 641 - 650 interview questions
See Interview Questions for Similar Jobs
Wireless Communication Systems EngineerElectrical Engineer ISignal Processing EngineerCommunications EngineerSignal Integrity EngineerTelecom EngineerTransmission EngineerRfic Design EngineerApplications EngineerRf ManagerRf TechnicianMicrowave EngineerSatellite EngineerAntenna EngineerLte Test EngineerWireless EngineerElectromagnetic EngineerTelecommunications EngineerDsp Engineer