What are the different ways you can you tell if this part is steel or aluminium.
Design Coordinator Interview Questions
31,043 design coordinator interview questions shared by candidates
Questions that popped out as I can remember. 1) A cube (1-1-1m) of ice in a room (50C) sitting on a wooden table. the ice is 1m away from the walls around it's 4 sides, except for 1 side is 30cm away. You're given 2 insulating blankets (1m by 1m) that can be used to cover the ice block. The goal is to keep the ice in solid form as long as possible. Where would you put the blankets? 2) 2 rectangular beams, one is Aluminum a by 2b cross-section one is Steel a by b cross-section. If you were to climb a mountain and find these two sticking out on a spot where you need to rest, which one would you latch on to? 3) Interviewee shows a plastic part and asks: How do you think I built this part? What other ways can you think of this part could have been done?
What is the difference between stress and pressure Difference between axle and shaft. What is CATIA. Expand. and other questions related to CATIA
If you had a hot coffee mug in a room, what information would you need to derive the heat transfer equations?
What will be the output if 100 volt DC is fed into 1:2 Transformer ?
Consumtions with and without pipeline, how to test ASICs, how would you get to know if a number is a power of 2.
- How will you reduce the deflection of a wooden beam with load at one end and fixed at other? - Beam material replaced with Aluminum and load is same, how will you find the point of failure? - 5 methods to join plastic and metal components.
What kind of plastic would you use for an electronic housing?
1. what are the areas you are interested to work?
Why do you want to join the company
Viewing 31 - 40 interview questions