I applied through a recruiter. The process took 3 months. I interviewed at Apple (Cupertino, CA) in May 2022
Interview
Initial phone call with the recruiter, then a 45 minute initial screening with a manager. Was asked about my experience. Not many technical questions. Was contacted by the recruiter a week later and given a design challenge. Had 2 weeks to complete the design challenge. After I submitted, I was scheduled for an onsite with 6 people, 45 minutes each and the recruiter for 30 minutes. Then presented my design challenge for an hour with the team of engineers where they asked design decisions. I was given 5 minutes at the end of each interview to ask questions. After, recruiter reached out telling me the team wanted to bring me on board, then GHOSTED. The interviewers were friendly but the process is arduous and leaves a super bad taste to not have the courtesy to follow up after I spent so much time interviewing. The process was also SUPER long and the design challenge took 30+ hours to complete. Crazy how much time commitment they expect. The entire process from the initial contact with the recruiter has been 3 months.
Interview questions [1]
Question 1
Given two blocks, how would I design the assembly such two faces are flush and where would I assign the datums.
Questions on picking on datums and GD&T.
Classic Beam question, shear moment diagrams
I applied online. The process took 4 weeks. I interviewed at Apple (San Jose, CA) in Apr 2021
Interview
1) Received email from recruiter for technical screen
2) Hiring Manager Screen interview -30 min
3) Problem Statement - 2 weeks
4) Interview with Team - ( interview lasts the entire day, interviewed with 10 people back to back with breaks)
5) Project Presentation
I applied online. The process took 3 weeks. I interviewed at Apple (Los Angeles, CA) in Apr 2022
Interview
I had one 30 minute phone call, week long design challenge, had to answer questions regarding design and send back presentation, all day interview, and one hour presentation on design challenge
Interview questions [1]
Question 1
What are common defects when doing injection molding